ADA Depot - A Forum To Support Users of ADA Amplification Gear

Other ADA Gear => ADA Effects => Topic started by: frehley6986 on February 11, 2021, 06:17:20 AM

Title: Pitchtraq Battery Replacement
Post by: frehley6986 on February 11, 2021, 06:17:20 AM
Is there a battery mod/holder that works in the Pitchtraq similar to the MP-1?

If not what is the correct battery to replace it with? I don't know if mine is bad but I bought the unit used and
I'm guessing it should be replaced.

TIA
Title: Re: Pitchtraq Battery Replacement
Post by: MarshallJMP on February 12, 2021, 02:11:45 AM
Same as for the mp-1, you can use a CR2032 + battery holder
Title: Re: Pitchtraq Battery Replacement
Post by: frehley6986 on February 13, 2021, 02:00:18 AM
Thank you
Title: Re: Pitchtraq Battery Replacement
Post by: frehley6986 on February 19, 2021, 10:49:51 AM
I did the battery mod today on my Pitchtraq.

The battery holder didn't want to go in as the posts were a little too wide. I used my dremel and ground down the sides of the posts
on each leg of the holder. It then popped in and I soldered it up.

Thanks MarshallJMP
Title: Re: Pitchtraq Battery Replacement
Post by: MarshallJMP on February 19, 2021, 12:39:56 PM
No problem, glad I could help  :thumb-up: