Richards MP2 Patches

[rnolan]

Ok at Wills request here are the 3 MP2 patches I currently use, these patches are for Ultasonic Reference Series pick ups which aren't made anymore.  The early Tom Anderson guitars had them, now he makes his own.  They are very "flat" pickups not middy like other PUs so you may have to compensate a little to get the best from these patches.

Main Rhythm Patch (and lead, I use the volume pedal to crank up for solos')
Voice    5 Warm Vintage
Drive    90
OD    N/A
Master    65
Comp    Out
Lo     +2
Mid    -8
Hi     +8
Pres    0
100 Hz    0
170    0
280    -2
470    0
800    0
1.3khz    -2
2.2    -2
3.8   +2
6.3    0
Wah    out
Trem    out
NR    out
Chorus    In depth 100, rate 0.0hz
EffLoop    In   

Lead Patch (used to be my main rhythm patch)
Voice    9 Ultra High Gain
Drive    70
OD    100
Master    77
Comp    Out
Lo     +2
Mid    -6
Hi     +6
Pres    +6
100 Hz    0
170     +2
280    -6
470    -2
800    -2
1.3kHz    -2
2.2    -4
3.8     +2
6.3    -2
Wah    Out
Trem    Out
NR    In, Fader, Thres 25
Chorus    In Depth 100, rate 0.0
EffLoop    Out

My Clean sound (Note: this also relies on particular guitar settings.  Ultrasonic PUs (3s ie single coil shaped but dual coil), Neck Series, Middle Parallel
(and it's as low as I can make it in the guitar so I don't hit it with the pick (ala Blackmore)))  Bridge off. Very "glassy" sound.  On my Anderson, each PU
has a 3 pos switch, down coils in series, middle off, up coils in parallel
Voice    1 Crystal Clean
Drive    37
OD    N/A
Master    66
Comp    In 10:1, Thres 52, Gain 50
Lo     +4
Mid    0
Hi     +4
Pres     +6
100 Hz    +4
170    0
280    0
470    0
800    0
1.3kHz    0
2.2    0
3.8     +2
6.3     +6
Wah    Out
Trem    Out
NR    Out
Chorus    In Depth 60%, Rate 0.3Hz
Eff Loop Out

[W.Laturno]

Cool man, thanks.  I'll give 'em a try and provide some feedback ( no pun intended ).

Regards,
Will.

[dbjacobson2112]

thx for posting these - will try them tomorrow

[rnolan]

No worries, you may have to tweak the gain and eq a bit for your PUs, the Ultrasonics I use are quite high output and very flat.  I also add a bit of light delay and reverb from the Quadverb.

[rnolan]

MP2 factory patch (01 and 16) for Dante  :wave:
01 Big Fat Crunch
Patch 01 = V: 9 Ultimate High Gain, drive 70, OD 100, master 69,  comp out, L +12/ M -12/H +6/ P +6, 100hz +10/ 170hz +2/ 280hz -6/ 470hz -2/ 800hz -2/ 1.3khz -2/ 2.2khz -4/ 3.8khz +2/

6.3khz -2, wah out, trm out, NR in/gate/thhld 30, St Chorus in Depth 34% rate 0.2 hz, loop in/Mix A & B 25% wet/

16 On The Verge
Patch 16 = V: 4 Vintage Brown, drive 37, master 80,  comp out, L +4/ M -6/H +6/ P +8, 100hz +10/ 170hz +4/ 280hz 0/ 470hz 0/ 800hz -2/ 1.3khz 0/ 2.2khz +4/ 3.8khz +2/ 6.3khz +2, wah out, trm out, NR out, St Chorus out, loop in/Mix A & B 25% wet/

FX  Quadverb:
Stereo Delay L 120ms/FB 26% R 240ms/FB 36%
Pitch Mode = Stereo Chorus, Squarewave, LFO Sp 01/ depth 63/ pitch FB 37%
Reverb = Chamber1 predelay 74ms/ Rev decay 50/ diffusion 6/ density 7

[rnolan]

MP2 Clean patches (there's sound bights of these in this thread (http://adadepot.com/index.php?topic=1008.0))
Patch 110 = V: crystal clean, drive 37, master 66,  comp in 10:1 thhd 52 gain 50, L +4/ M 0/H +4/ P +6, 100hz +4/ 0000/ 3.8khz +2/ 6.3khz +6, wah out, trm out, NR out, St Chorus in Depth 60 rate 0.3 hz, loop out.

Patch 111 = V: crystal clean, drive 39, master 70,  comp in 10:1 thhd 52 gain 50, L +4/ M -2/H +8/ P +6, 100hz +8/ 170hz +2/ 000/ 1.3 khz +2/ 2.2 khz +2/ 3.8khz +2/ 6.3khz +8, wah out, trm out, NR out, St Chorus in Depth 50 rate 0.4 hz, loop out.

FX  Quadverb:
Stereo Delay L 120ms/FB 26% R 240ms/FB 36%
Pitch Mode = Stereo Chorus, Squarewave, LFO Sp 01/ depth 63/ pitch FB 37%
Reverb = Chamber1 predelay 74ms/ Rev decay 50/ diffusion 6/ density 7