ADA Depot - A Forum To Support Users of ADA Amplification Gear
FREE CLASSIFIED ADS => Buy & Sell ADA Gear => Topic started by: sizzlemeister on April 22, 2014, 08:11:43 AM
-
Greetings! Shipping is to USA only. Both units are v 1.38.
ADA MP1 #1
Faceplate looks good. Fully functional. Typical scratches. Some one painted the top plate ages ago - looks fine.
When I got it, someone had modded the bejesus out of it. I restored most of it to stock, except for some stuff in the gain stages. I kind of liked the additional gain. I'd say it has about 40% more gain than normal, you can use lower settings to make it sound (more or less) like a stock unit. If you want to make it completely stock, you're looking at about $5 in parts and about an hour and half on the bench.
I just did the extensive noise mod, replaced the front and rear input jacks. Has new power supply caps and new memory battery.
$155 plus shipping
ADA MP1 #2
Faceplate looks good. Fully functional. Typical scratches. Overall, considering these are beat on, looks good and performs well.
This is stock. Sounds like a MP1 should.
I just did the extensive noise mod, replaced the front and rear input jacks. Has new power supply caps and new memory battery.
$185 plus shipping
This is the $155 MP1:
(http://www.imaginationgraphicsandsound.com/pics/MP1_2_front2.jpg)
(http://www.imaginationgraphicsandsound.com/pics/MP1_2_front.jpg)
This is the $185 MP1:
(http://www.imaginationgraphicsandsound.com/pics/MP1_1_front2.jpg)
(http://www.imaginationgraphicsandsound.com/pics/MP1_1_front.jpg)
PM or email sizzlemeister -at- gmail -dot- com