Dante's Rig(s)

[Dante]

I'm following Kim's lead here, using a link to this post in my signature instead of having all that garbage at the bottom of each and every post

ADA Gear
Preamps: MP-1 Classic, MP-2
Power Amps: Microtube MT-200, MicroTube 100
Pedals: MXC control switch with Quad switch and CC pedal

Gig Rig (wait 10 minutes, it'll change)
Hughes & Kettner Grandmeister 40 Deluxe head into two Yamaha 1x12 cabs. I use a Boss MS-3 for effects and as a midi footswitch for the amp.

When I have enough room onstage, I bring the H&K stack and my H&K Switchblade 50 combo and run them on either side of the stage in stereo 

Backup rigs: Hughes & Kettner Switchblade 50 combo, and a Peavey Classic 20 Mini Head with matching tweed oversized 1x12 cab (this amp rocks) - each uses the Boss MS-3 for effects and switching

[DannyjoeCarter]

I'm following Kim's lead here, using a link to this post in my signature instead of having all that garbage at the bottom of each and every post

ADA Gear
Preamps: MP-1 Classic, MP-2
Power Amps: Microtube MT-200, MicroFET
Pedals: MXC control switch with Quad switch and CC pedal

Gig Rig (wait 10 minutes, it'll change)
Hughes & Kettner Grandmeister 40 Deluxe head into two Yamaha 1x12 cabs. I use a Boss MS-3 for effects and as a midi footswitch for the amp.

Backup rigs: Peavey Classic 20 Mini Head with matching tweed oversized 1x12 cab (this amp rocks), Hughes & Kettner Switchblade 50 combo

Great setup dante! I remember the microtube being a pretty sweet little preamp, but I don't remember if you can run to 412's off it?

[Dante]

Sorry man, I guess I didn't see your message there ....Hell yeah, the Microtube can power 4x12s! Shoot, my Peavey sounds great through one too 

The Microtube is a power amp, not a preamp, btw

[Dante]

Pedalboard & Signal chain: It looks complicated, and I admit I had some extra time when I did this, but it's pretty straight forward. See the attached diagram below, here's an explanation; 

The Boss MS-3 runs/controls everything. All FX (except a couple pedals) are in there, and all external stuff runs through it somehow...It has 3 loops

Loop 1: Outboard effects (Wah pedal, Octaver & Mojomojo OD)
Loop 2: Amp (via 4 Cable Method)
Loop 3: not used

Notice I have the stomp boxes before the amp, and I have another loop available if I want anything after the amp, but before my stereo delay pedal....

When the signal leaves the MS-3, each output runs into the Echolution 3 L/R. That signal runs out to the amps for each side; 
Side A: to the input of the main preamp I'm using
Side B: Into the FX Return of the amp I'm using as a slave (bypasses the preamp, just uses the power amp this way)