ADA Power Amps > B200s

B200s reflow

<< < (2/2)

MikeB:
Have posted more on my MP1 issue in the troubleshooting section:
http://adadepot.com/index.php?topic=1160.msg9249#msg9249

VoxG2:
   Where does one have a B200S reflow done? Thanks.

rnolan:
I did it myself, it's actually not hard to do, just pull it apart, re-melt all the solder joins, feed in a bit more solder if they need it, B200s are not a complicated amp.  But if you are't up to using a soldering iron, any tech could do it for you, probably about 1 hours work (including pulling apart and reassemble)

VoxG2:
  Hmmmmm...ok. Thank you!!

Navigation

[0] Message Index

[*] Previous page