ADA Depot - A Forum To Support Users of ADA Amplification Gear
Non ADA Gear => Basses => Topic started by: rnolan on May 28, 2021, 10:06:33 PM
-
A friend I'm teaching guitar bought a Taylor Baby Bass. I had a play at her lesson this week. Nice little bass (though not cheap $1300 AUD). Seems to be maple back sides and neck with a spruce top and rosewood finger board. The pick up seems to be a piezo under the saddle and the little preamp (vol, tone, tuner) runs on 2 x CR2032 button batteries (not seen that before). It distorted a bit from time to time but otherwise worked reasonably well. The tuner is pretty basic and not particularly accurate, but usable. I recorded a bit of stuff for her to play along with into her Roland RC-30 loop station (interesting gadget, I've never used one before). Last thing I did was oil the finger board with some dunlop 65 lemon oil (it needed a drink even though it was new) and took out a little neck relief (fortuitously I have a taylor neck wrench/socket that came with my baby taylor, they don't seem to include them these days, I suspect it's the same size as the Gibson neck adjusters). The adjustment made all the difference, brought the action down a bit and now plays even better.Initially I ran it through my MB-1 > desk > B200s > Messa P112 cabs, sounded very nice. The MC-30 L/R > desk, also sounded great but wanted to feed back (as acoustic things tend to). Definition between open E and F wasn't great, then that's common on very short scale basses. But that was my only complaint. They would make a nice addition to your setup if you want something compact to add a bit of bass to your recording etc.