Noise mod v2 question/confusion

[grindliner]

So, I have searched to no avail

MJMP modshop's parts list calls out:
4 - 33uf/50v
7 - .047uf/50v
4 - 10uf/35v

The V2.o noise mod document makes no mention of these parts.
Where do they go?

Are the 10uf/35v are non polarized?

Thanks in advance

[rnolan]

Hey grindliner.  zip file attached, hope it helps

[rnolan]

Or you could have checked The Vault which has the pdf version (attached).

Sorry, I just re-read your post, you have the document.  So this is a MJMP question LoL.

[grindliner]

yeah, thanks, I have those.

I didn't realize until yesterday that MJMP's was it's own separate thing (or is it?) lol. Maybe his would be considered Noise mod V3.0, or 2.5?

Bottom line, I have 2 units to do, a 1.38 with a rev F board, thats a basket case, and a 2.0.

I am restoring these, and have no intentions of modding these beyond the noise mod, battery holder, and MDRT if needed.

PAGING #mjmp

[MarshallJMP]

4 - 33uf/50v
7 - .047uf/50v

These normally go to replace the small caps near the voltage regulators

5 - 10uf/35v

These are the NP caps that replace the elektrolytic caps on the tube board.

[grindliner]

Thanks Philippe, Much appreciated, I did see on one of the MP-1 related sites, that if I wanted to replace all non-polarized electrolytics, the quantity is 38,