Had the live rack set up for a bit now and been tinkering with it, mostly playing my new JPLP through it for hours and going to bed way late (well early morning really LOL).
I posted my main QV patch a while ago with a couple of MP2 patches I listed for MJMP and Dante and thought you might see it, although is in MP2 thread
. (though I've included ALL the settings here)
So here's my main QV patch which I use for most everything:
FX Quadverb:
Configuration: EQ->PITCH->DELAY->REVERB
Mix: Direct signal select: pre-eq/direct signal level +00/master FX level +99 (so full wet)/pitch output level +00/delay output level +31/reverb output level +99
EQ: low eq freq 100/low eq amplitude +03.00 dB/mid eq freq 2000Hz, bandwidth 1.00 octaves, amplitude 0/hi eq freq 10000Hz, amplitude +04.05 dB
Pitch Mode = Stereo Chorus/ pitch input post-eq/LFO waveshape Square/ LFO Speed 01/LFO depth 63/ pitch FB 37%
Stereo Delay /del input 1: pre-eq/delay input mix: 1 <-99 pitch/L 120ms/FB 26% R 240ms/FB 36%
Reverb = Chamber1/rev input 1: pre eq/rev input 2: delay output/rev input mix 1<-00->2/ /predelay 74ms/ pre delay mix: pre 80 -> post/Rev decay 50/ diffusion 6/ density 7/ rev gate off
So as pitch input is post eq and pitch output is 0, neither the chorus or eq is used but I listed them all.
Both delay and rev inputs are pre-eq so this patch is just delay and reverb. Also I didn't list the reverb Gate parameters as it's off.
BTW my QV is a very early one, there were I think some firmware updates available later but I didn't know about them so it's stock. Also I spotted a QV2 in someones rack the other day and it's a much later unit.
I used to have a long mono delay back in the day and also a flange patch for white wedding, as I tinker more I'll post them if they still exist, I may have lost them when I though the battery was dead, turned out tech couldn't get a battery for it but the original battery was fine... though I seem to remember loosing all my patches and starting again
it was a long time ago.