ADA Depot Too - A Forum To Support Users of ADA Amplification Gear

Please login or register.

Login with username, password and session length
Advanced search  

News:

Board added for "Routing & Patching" in Lets Get Technical

Pages: 1 [2]   Go Down

Author Topic: 4ohm Resistor Across C131 & D38 ?  (Read 2067 times)

0 Members and 1 Guest are viewing this topic.

red2203stack

  • Newbie
  • *
  • Offline Offline
  • Posts: 14
Re: 4ohm Resistor Across C131 & D38 ?
« Reply #15 on: Time Format »

A cheap, high maintenance chinese 852D+. But it gets the job done.
Logged

red2203stack

  • Newbie
  • *
  • Offline Offline
  • Posts: 14
Re: 4ohm Resistor Across C131 & D38 ?
« Reply #16 on: Time Format »

Using a cheap, high maintenance, Chinese 852D+ but it gets the job done.

So far I channged out the 2200uf and 3300uf caps. That made a huge improvement, but the original caps were on their last leg.

Then I changed all electrolytic's on the tube board with original values. Again a noticeable improvement in noise and the original tone is still there. It's not completely quiet, but back to within reason and my Boss NS-2 can handle the rest.

All thats left is the front input jack and pot..Still not sure if I should replace the .047uf ceramic disc and voltage regulators.
Logged
Pages: 1 [2]   Go Up