ADA Depot - A Forum To Support Users of ADA Amplification Gear
Let's Get Technical => Power Amp Tech => Topic started by: BoWeevil on July 07, 2014, 09:00:28 PM
-
Hey All,
Just picked up my second MB-1 and the matching B500B from the original owner!
Pretty stoked, but the fan on the 500B is really loud!
I took the fan out and gave it good cleaning, but the noise still remains.
I started poking around on eBay, but this particular model doesn't seem to want to show up in my searches.
I have attached a pic of the specific model, but its an IMC PEWEE BOXER, Model # 3115FS 12T B20, 115V.
Looking forward to any and all suggestions on a decent replacement.
Thanks!
-
Hey BoWeevil, I didn't know any ADA gear had fans in them ?? But B500s' are not as common...and it would make sense as the B200s's gets very warm..
I assume you could go for an equivalent fan, MJMP or Sparker may have better suggestions ?
-
Did you try spraying any WD-40 (or equivalent) into the bearings + shaft? Might do the trick (use the long thin tube to get right inside).
-
Or you could also try some Teflon like they sell for pushbike wheel hubs/chains ?