ADA Depot - A Forum To Support Users of ADA Amplification Gear

ADA Power Amps => B200s => Topic started by: rennerskt on December 10, 2014, 01:44:18 PM

Title: ADA B200 and ADA MP-1 volume controls
Post by: rennerskt on December 10, 2014, 01:44:18 PM
Hi there,

I have just bought an ADA B200 to use it with my ADA MP-1. Since this is my new rig (I used to play with combos) I have some dumb questions.

Should I have the power amp volume control set to max and control it with the preamp, or should I do the opposite?

Best Regards,

Roberto Renner
Title: Re: ADA B200 and ADA MP-1 volume controls
Post by: rnolan on December 11, 2014, 04:45:29 AM
Hey Roberto, (Should I have the power amp volume control set to max and control it with the preamp) Yes and that will give you maximum headroom. That said, in reality, the B200s is a very loud amp  >:D and in my extensive experience with Mp1/2 through B200s, I never got past 3/4 (3 O'clock) on it's vol controls. Remebering that if you open the amp up full (and what you would typically do with PA amps etc), you experience it's quoted noise ratio (and B200s is pretty good IIRC). I've found it's more about the intensity (and the neighbors). But fundamentally you want to crank the power amp and adjust at preamp.
Title: Re: ADA B200 and ADA MP-1 volume controls
Post by: rennerskt on December 11, 2014, 09:18:31 AM
Thanks rnolan and sorry for the dumb questions I have been asking. This is the only place to solve my doubts.

Best Regards,

Roberto Renner
Title: Re: ADA B200 and ADA MP-1 volume controls
Post by: rnolan on December 12, 2014, 02:28:26 AM
Happy to help my friend, hey if you don't know the answer, the question isn't dumb  :wave: :thumb-up: