Got a funny one here (funny strange, NOT funny ha ha). My battery went dead last week and I lost all of my patches. I have replaced the battery and upgraded from 2.0 to 2.1 eprom while I was at it. I reloaded my last backed-up patches and then decided to rebuild from scratch anyway.
I operate parallel sets of patches. One set turns on the effects loop where I have a GCS-3 plugged in so that I can play with headphones or direct into a desk. The other set has the same settings but with the loop off. I roughed up my new patches with the headphones and have just been copying them down to the other bank so that I can fine tune them at volume through a cabinet. After copying them all down I have to go through each one and turn the effects loop off. This worked fine for a couple of them but some of the others won't change from "in" to "out" when I edit the patch.
What the hell is going on here?
Just gone and done a quick experiment. Going back to my effects "in" bank, the corresponding ones that I couldn't modify on the effects "out" bank also wouldn't change from "in" to "out". I copied a patch that was working over the top of one that wasn't and found that it now works. So this inability to change the effect loop setting can be over written.
Is this just freak event or a harbinger of doom and sorrow?