That was my original plan but one of the power amp tubes has died on the left hand side so only the right works.
When i was running one output from the ada into the right side it was sounding good, but then when i put both A and B outputs into the A and B inputs of the Right side, the volume difference was huge!! I guess with the Engl say i was running a mono preamp i could have say the ADA into the A and another amp to the B input and there is a switch at the front which changes between A and B, obviously in my case though this does not change anything as both inputs have the ADA in.
I have included the ENGLs manual so everyone can have a look at it!
Possibly thinking as both ADA outputs are into the AB right inputs, maybe put another speaker cable out of the right side 4ohms and change the existing 8ohm to 4ohm then run my amp in stereo?
Finally messed around with it yesterday for the first time, had a good chance to go through everything, was going to drop you a message. It sounds really good!!! That squealing is still there but i think thats something with eq because when i set the ada eq flat and used an mxr 10 band through the effects loop, boosting some frequencies did producing some constant squeals even if i was on the clean channel, i will just have to figure a way around it.
There was an issue with OD 1 occasionally popping when going from 2.2-2.4, some hissing at 3.4 then popping and going silent to 3.6 then a pop at 6-6.5 then after that i barely could hear a difference between 6-10 when adjusting up or down.
I was working through the Nuno and Paul Gilbert ADA patches and was trying to figure out the best set up as with Nuno`s patches he has the output volume around 1-2 o'clock and most of his master gains for clean and distorted are at 3.5 max. While some of PGs tones vary and at 1-2o clock output volume is very loud for some of his patches. So i am trying to figure out what is the best method, run the output volume pretty high 1-3 o'clock, then adjust all of my patches so their master gains never really go past 3-4 and then push the volume out on my ENGL, or run the ADA output volume around 10-12 and then crank the master gain of the patches up to 6-8?