Let's Get Technical > Troubleshooting Problems

4ohm Resistor Across C131 & D38 ?

<< < (4/4)

red2203stack:
A cheap, high maintenance chinese 852D+. But it gets the job done.

red2203stack:
Using a cheap, high maintenance, Chinese 852D+ but it gets the job done.

So far I channged out the 2200uf and 3300uf caps. That made a huge improvement, but the original caps were on their last leg.

Then I changed all electrolytic's on the tube board with original values. Again a noticeable improvement in noise and the original tone is still there. It's not completely quiet, but back to within reason and my Boss NS-2 can handle the rest.

All thats left is the front input jack and pot..Still not sure if I should replace the .047uf ceramic disc and voltage regulators.

Navigation

[0] Message Index

[*] Previous page