ADA Depot - A Forum To Support Users of ADA Amplification Gear
Other ADA Gear => ADA Effects => Topic started by: ADA Amplification on October 15, 2018, 03:02:22 PM
-
We have started a short run of original ADA Flangers using the Reticon SAD1024 bucket brigade chip! We found a few of the rare parts and are using the original printed circuit board layout and component values to achieve the exact same product A/DA shipped in 1978. We are using the same "big box" aluminum sand cast enclosure. The original Flanger ran off 18V DC and using an obsolete 2.5mm center pin positive AC Adapter. The only change we have made is to use a 2.1mm center pin negative DC power jack, which is standard for today's pedal boards.
-
:whoohoo!: very cool :thumb-up: , how much (incl shipping) to send one to Australia (with a 240v adapter) ? PM me please :wave:
-
Folks, please be considerate of the OP's thread. C:-)
The rack gear discussion on this thread has been moved to Re: Mp-3? (http://adadepot.com/index.php?topic=2238.msg25539#newDisc)
-
We have started a short run of original ADA Flangers using the Reticon SAD1024 bucket brigade chip! We found a few of the rare parts and are using the original printed circuit board layout and component values to achieve the exact same product A/DA shipped in 1978. We are using the same "big box" aluminum sand cast enclosure. The original Flanger ran off 18V DC and using an obsolete 2.5mm center pin positive AC Adapter. The only change we have made is to use a 2.1mm center pin negative DC power jack, which is standard for today's pedal boards.
Fantastic! How does one get it?