110 below is same as in MP2 patch post and same NOTE these depend very much on the guit PU settings and sound VERY different with just a standard PU selection (and not necessarily clean, so will need tweaking to accommodate (eg back off guit vol, use out of phase/coil split settings)).
Guit = Anderson Pro Am (basswood body), neck PU and middle PU = Ultrasonic Ref3s (both single coil sized dual coil). Each PU has 3 way toggle (series/off/parallel), for this patch I have Neck series, Middle parallel. And the most important is the Middle PU is as far away from the strings as it goes (this was a happy accident as it's wound down into the guitar to be out of the way of my pick, then I tripped over how good it sucks the volume switched in parallel with the neck PU full blown series and gives a great glassy sound)
MP2 Clean patches
Patch 110 = V: crystal clean, drive 37, master 66, comp in 10:1 thhd 52 gain 50, L +4/ M 0/H +4/ P +6, 100hz +4/ 0000/ 3.8khz +2/ 6.3khz +6, wah out, trm out, NR out, St Chorus in Depth 60 rate 0.3 hz, loop out.
Patch 111 = V: crystal clean, drive 39, master 70, comp in 10:1 thhd 52 gain 50, L +4/ M -2/H +8/ P +6, 100hz +8/ 170hz +2/ 000/ 1.3 khz +2/ 2.2 khz +2/ 3.8khz +2/ 6.3khz +8, wah out, trm out, NR out, St Chorus in Depth 50 rate 0.4 hz, loop out.
(for Soloist) FX Quadverb (mixed in via 2 aux sends (MP2 A Aux 1 / MP2 B Aux 2 > QV L/R in) on desk and return QV L/R out down stereo channel):
Stereo Delay L 120ms/FB 26% R 240ms/FB 36%
Pitch Mode = Stereo Chorus, Squarewave, LFO Sp 01/ depth 63/ pitch FB 37%
Reverb = Chamber1 predelay 74ms/ Rev decay 50/ diffusion 6/ density 7 (low and hi pass both 00, no gate)
I set up a pair of Rode NT5s on my stereo cab last night, into TLA Ivory 5001 quad tube (hybrid) preamp so I'll record a sample of each later tonight and post.