Hey MJMP, If I dial up my highest gain patch with chorus on and nothing plugged in, all leds are off. Just tried it again with same patch and turned chorus off/on, there is signal in the chorus circuit (from leds point of view) regardless of on/off status, so chorus green led on high gain is normal (regardless of chorus status)
@ MJMP, highly recommend you load up my 2 distorted patches (112, 113) in your MP2 and give it a go
(loud!!).
Or you may like my 119
(Voice 9, D70, OD80, M85, L+10, M-6, H+8, P+6; (100hz +6, 170 +2, 280 -6, 470 -2, 800 -2, 1.3khz -2, 2.2 -4, 3.8 +2, 6.3 -2)), NR In/fader Thresh 50, chorus in D34, R 0.2. This is the patch I just used to check above.. run your cab sim outs (I use 2 x 12 setting) into 2 channels, put on a little shortish stereo delay (174/340) and a nice hint of reverb. This isn't a patch I've used for quite a while, but listening to it then through the studio monitors... MMmmmm For those about to rock... is what I played.