ADA Depot - A Forum To Support Users of ADA Amplification Gear
ADA Preamps => MP-2 => Topic started by: rnolan on December 29, 2014, 07:30:08 AM
-
So I've just been going through my MP2 factory settings (haven't been here for years...01 Marshall mmmm kicks arse >:D ) with my new JPP LP >:D , got to patch 16, On the Verge, what a great patch, a touch of delay/reverb and how it sings... Time for bed, more tomorrow... >:D
-
R,been playing with my mp-2 as well so could you post some clean presets that you use?
-
110 below is same as in MP2 patch post and same NOTE these depend very much on the guit PU settings and sound VERY different with just a standard PU selection (and not necessarily clean, so will need tweaking to accommodate (eg back off guit vol, use out of phase/coil split settings)).
Guit = Anderson Pro Am (basswood body), neck PU and middle PU = Ultrasonic Ref3s (both single coil sized dual coil). Each PU has 3 way toggle (series/off/parallel), for this patch I have Neck series, Middle parallel. And the most important is the Middle PU is as far away from the strings as it goes (this was a happy accident as it's wound down into the guitar to be out of the way of my pick, then I tripped over how good it sucks the volume switched in parallel with the neck PU full blown series and gives a great glassy sound)
MP2 Clean patches
Patch 110 = V: crystal clean, drive 37, master 66, comp in 10:1 thhd 52 gain 50, L +4/ M 0/H +4/ P +6, 100hz +4/ 0000/ 3.8khz +2/ 6.3khz +6, wah out, trm out, NR out, St Chorus in Depth 60 rate 0.3 hz, loop out.
Patch 111 = V: crystal clean, drive 39, master 70, comp in 10:1 thhd 52 gain 50, L +4/ M -2/H +8/ P +6, 100hz +8/ 170hz +2/ 000/ 1.3 khz +2/ 2.2 khz +2/ 3.8khz +2/ 6.3khz +8, wah out, trm out, NR out, St Chorus in Depth 50 rate 0.4 hz, loop out.
(for Soloist) FX Quadverb (mixed in via 2 aux sends (MP2 A Aux 1 / MP2 B Aux 2 > QV L/R in) on desk and return QV L/R out down stereo channel):
Stereo Delay L 120ms/FB 26% R 240ms/FB 36%
Pitch Mode = Stereo Chorus, Squarewave, LFO Sp 01/ depth 63/ pitch FB 37%
Reverb = Chamber1 predelay 74ms/ Rev decay 50/ diffusion 6/ density 7 (low and hi pass both 00, no gate)
I set up a pair of Rode NT5s on my stereo cab last night, into TLA Ivory 5001 quad tube (hybrid) preamp so I'll record a sample of each later tonight and post.
-
Here's patch 110:
-
Here's 111:
-
So rig is my live rig with a pair of Rode NT5s micing my ADA stereo (wired) cab and Ivory TLA quad tube preamp.
-
Ok will try these settings out.Thanks
-
So I've just been going through my MP2 factory settings (haven't been here for years...01 Marshall mmmm kicks arse >:D ) with my new JPP LP >:D , got to patch 16, On the Verge, what a great patch, a touch of delay/reverb and how it sings... Time for bed, more tomorrow... >:D
Hey Richard, would you mind posting the two patches you mention in this thread? (01, 16)
Dante
-
MP2 factory patch (01 and 16)
01Big Fat Crunch
Patch 01 = V: 9 Ultimate High Gain, drive 70, OD 100, master 69, comp out, L +12/ M -12/H +6/ P +6, 100hz +10/ 170hz +2/ 280hz -6/ 470hz -2/ 800hz -2/ 1.3khz -2/ 2.2khz -4/ 3.8khz +2/ 6.3khz -2, wah out, trm out, NR in/gate/thhld 30, St Chorus in Depth 34% rate 0.2 hz, loop in/Mix A & B 25% wet/
16 On The Verge
Patch 16 = V: 4 Vintage Brown, drive 37, master 80, comp out, L +4/ M -6/H +6/ P +8, 100hz +10/ 170hz +4/ 280hz 0/ 470hz 0/ 800hz -2/ 1.3khz 0/ 2.2khz +4/ 3.8khz +2/ 6.3khz +2, wah out, trm out, NR out, St Chorus out, loop in/Mix A & B 25% wet/
-
Hey Dante, I also posted these 4 patches (01, 16, 110 and 111) in the MP2 patches topic
-
Thanks Man!!
I'm going to try those this weekend. I am trying really hard to get my MP-2 back into the main rack, but the MP-1 Classic seems to be winning the battle right now. Maybe these patches will help :dunno:
:ada-big:
-
Ahh choices choices LOL Try my rhythm/lead post and old rhythm lead (112 and 113) as well. 112 is a great all round rock patch, back of vol knob to clean it up a little or crank for solo. It's the one I use 90% of the time and I ride the midi master vol with the MXC pedal.