@Richard
Yes i have read the Tubes thread and it's a very interesting one with many options, so kind of at a loss as to which pairings might be best, I see you recommended the Mullard short plate and the SPAX7 (Mikes set up) tho you say you prefer the Mullard Long plate (what's the difference between the short & long and can you say why you prefer the long ?).
I've actually just ordered a new helping hands, with magnifier & light and had recently just upgraded my soldering gear.
I would like to try do some of the mods myself (i suppose if i make a mess of it i can always still send it over to MJMP's anyway) telling him what i exploded.
Well new valves first of course, then what ? Battery, Noise, MDRT, Jack sockets
In what order would you recommend doing the mods ?? is there a preferred order at all ?
Ohh and as for Stereo cabs, my 4 x 12 is actually an old original Line 6 412s Stereo cab with the eminence speakers 75 each so a 300 watt cab
only thing is I have NEVER used it in Stereo I always just used it mono to be honest I'm not too sure how to set it up as Stereo
perhaps you can elaborate !
On the back it has 2 inputs and switchable options these are:
LEFT/Mono : 16 ohm per side Stereo OR 8 ohm Mono(left only)
RIGHT : 4 ohm per side Stereo OR 2 ohm Mono (left only)
The 50/50 has a switch for each amp 8 or 16 ohm out for amp A and the same for Amp B
Would i just switch the cab to 16ohm and plug the left side into amp A and the right side into Amp B and set both Amp switches to 16 ohm ??
would that work then in stereo ?
Regards
scsi (Ray)