Other ADA Gear > ADA Effects

ADA S1000 Repair Issue

(1/4) > >>

thelangston:
Hey friends! I picked up an S1000 a week ago and got excited about adding it to my studio setup. I cleaned the pots and gave it a good deoxit treatment. When I power the unit on, the led’s are all permanently lit up and are unresponsive to the input signal. The input and output pots respond and pass signal, but the fx don’t work. As I move the mix knob to the right, my signal decreases until it’s nothing. It appears the effects aren’t working or getting signal perhaps? The pcb and components seem to be in good shape to my eye.

I’m quite handy with a soldering iron, so any help or advice on this would be greatly appreciated!
Thank you!

Matt

Dante:
Hi Matt,
Welcome to the Depot!
Have no fear, someone will chime in with an answer or at least a place to start (I am not that guy-sorry). Together though, we'll get that S1000 going (congrats on getting that!)
Best of luck!
Dante

thelangston:
Thanks Dante :-) Very excited about getting this working. I was able to find the schematic for it so maybe thats a good starting point. Looking froward to fixing it up with a little ehlp from the community.

MarshallJMP:
Hey, so what have you got to measure, multimeter, scope?

thelangston:

--- Quote from: MarshallJMP on December 11, 2023, 09:13:26 AM ---Hey, so what have you got to measure, multimeter, scope?

--- End quote ---

I only have a Kobalt DT-103 Mini Multimeter

Navigation

[0] Message Index

[#] Next page