No lights, no display, no sound

[MarshallJMP]

Can you also check pin 16?

[bunkyloo]

I have 3 volts on pin 16.

[emunstar]

Emunstar any luck with you're findings ?

I haven't had time to check anything further, hoping to dig back in soon.

[MarshallJMP]

Do you have access to a scope?

[bunkyloo]

I do not have one. If it is going to be needed I can look into getting one I suppose. Any specifics I would be looking for?

[MarshallJMP]

a 2 ch 20MHz will be fine.

[bunkyloo]

great I will look into it Thanks Steve

[bunkyloo]

Well I grabbed a cheap handheld scope. So go slow with the next tests Im just learning the basics with that thing. Thanks in advance.

[MarshallJMP]

Ok you got that Hantek 2D42 scope right?

You know what, maybe we can do a skype session, else it will take to long. Also then I can see what you measure, and I can tell you where to measure. And when we solve the problem we can put the problem and solution in this topic.

So send me an email to see when we can do this.

[bunkyloo]

Yep I did MJMP I hope its up to par and that's a great idea and makes sense I will email you soon. Thanks again.
Steve

[MarshallJMP]

From what I can see it should be on par. The highest frequency in the mp-1 is 12MHz.