Clip:
https://www.dropbox.com/s/obrf6799gfj6exu/EVH_Gear.mp3?dl=0Ends up being a bit of strange routing, might do a youtube video on it, but it's my 'live' tone.
A combo of W/DW and 4CM on the amp.
The main tone is my 5150 III EL34 50w in to matching 4x12 (Basically 20w Greenbacks).
Using a Rivera Rockcrusher in the chain so I can crank up the master a bit, to around 4.
I go guitar in to axe FX, and setup my pre effects blocks: wah, flange, phase, octave, eq, pitch
From there to my 5150 III input. Then I take the 5150 III pre-amp out back in to the Afx3.
Now here, is where I get a little crazy, and start taking advantage of the number of Axe 3 inputs
and outputs. Normally, I'd just throw some post gain effects in (chorus, delay, reverb) type and
send that to the power amp, or also out to the W part of the W setup. But, since I have 2 more
outputs, and 2 more inputs available, I don't do that.
This particular patch, is a blend of a few outputs. I have my SM57 on cab (main sound), direct (back from the pre-amp in to tube amp model in to my cab and 57 impulse) and wet sound (another input from the Rockcrusher back in to the axe on another line in, in to the impulse, through delay and reverb) all back in to my audio interface. Still playing around with it, but I am loving how it sounds.
So many videos out there on the modelling sounds, this version adds a variation to the routing that I think the surface is just being scratched on.
https://soundcloud.com/user-485788768/axe-fx-8cm