Hey Harley, good advice re knobs, I just put the originals back on. So I replaced the vol and 1st tone pot with the pull up pots (they do vol and series/parallel for bridge and neck PUs) and the 2nd tone pot does overall tone and is the original pot but I used much lower cap values so the tone control is much more subtle. Pulling up down the vol pot (bridge vol pot) is ok but the middle one (neck vol pot) isn't easy to get to. Also the neck is wired out of phase and I used a super switch (expensive puppies ($60)) wired b, b+m, b+n, m+n, n. Middle PU is what it came with screwed as low as I could get it to keep it out of the way of where I pick. A really neat, easy and effective wiring is like on my Anderson, so each (2 coil PU (3 PUs)) has it's own 3 way mini switch. Down is series, middle is off, and up is parallel so you can get any combination of those.
Hey Richie, you can no doubt get the push push online or buy one from the music shop. Deluxe guitars in Melbourne should either have them or can get them for you (seem like nice people, I bought my Peterson Strobo clip tuner from them, fantastic tuner BTW, best $75 I ever spent). You can buy some wire from Jacar, get some the same size as what comes from the PUs. You can cut some off the PU you take out and use that (I did that when I did the Squire wiring), or strip an old mic lead (preferably 2 core shielded as then you get 2 colours LoL) and extract the core wire, I've also done that a few times. You won't need much, just a couple of very shot bits for the switch jumpers. You can also cut a bit off the HR lead (4 cores
), It's quite long (made it from the neck PU cavity to the controls (just) when I did it) otherwise you have to coil it up and stuff it into the cavity around the pots. For the rest the wiring that's there already will be fine, though you may need a short bit (or 2) max 3" long probably.